Lambient

Ceramicomb

CeramiComb Reusable Ceramic Sensor

The Ceramicomb-1” is designed for use in presses, molds or harsh environments where a rugged, reusable dielectric sensor is desired. It may be mounted so the electrodes are flush with a platen or mold surface, insuring no interference with the flow of material during processing. The sensor is constructed with silver-palladium electrodes embedded in an alumina substrate, protected by a stainless steel sheath with a nominal 1.0” (2.54 cm) diameter. A thermocouple is positioned in the ceramic just below the surface to allow measurement of process temperatures.

Specifications
Varicon

Varicon Disposable Variable Conductivity Sensors

The Varicon sensor is designed for use in presses, molds, bulk materials or laminates where a thin, flexible dielectric sensor is necessary. Patterned on a polyimide substrate, the electrode array is designed to allow a choice of three sensitivities, which are selected by cutting off portions of the array at designated lines.

Specifications
Mini
varicon

Mini-Varicon Disposable Variable Conductivity Sensors

The Mini-Varicon sensor is a thin, flexible dielectric sensor designed for cost-sensitive use with presses, molds, bulk materials or laminates. Patterned on a polyimide substrate, the electrode array is designed to allow a choice of high or low sensitivity, selected by either using the whole sensor or cutting off a portion of the array at a designated line.

Specifications
micro
varicon

Micro-Varicon Disposable Variable Conductivity Sensors

The Micro-Varicon sensor is a miniature, thin, flexible dielectric sensor designed for cost-sensitive use where space is limited. The electrode array is patterned on a polyimide substrate, and the Micro-Varicon sensor can be supplied with or without Teflon insulated leads.

Specifications
single electrode
8mm / 12.5mm

Single Electrode Reusable Variable Conductivity Sensors

The 8-mm and 12.5-mm reusable dielectric sensors are designed for use in presses, molds or harsh environments where a tiny, reusable dielectric sensor is desired. It may be mounted so the electrode is flush with a platen or mold surface, insuring no interference with the flow of material during processing. The sensor is constructed with a stainless steel electrode embedded in a high temperature polymer sheath. The sheath has a nominal 8-mm diameter. An optional steel sheath increases the diameter to 12.5mm. A thermocouple is positioned in the sensor cable in the vicinity of the side exit joint to allow measurement of process temperatures.

Specifications
Custom
Sensors

We will design custom sensors for you to specifically target your needs.